Ruckus Wireless ZoneFlex 7055 User Manual page 133

Table 46. WLAN options (Continued)
Broadcast SSID
SSID
Threshold Settings
Rate Limiting
Access Control
Packet Forward
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A
This option controls whether or not the WLAN SSID is visible to
anyone looking for wireless networks. Disabling (hiding) the
SSID requires the user to be told the correct SSID before they
can connect to your network.
This is the publicly-broadcast "name" of your wireless network.
SSIDs can contain up to 32 alphanumeric characters and are
case-sensitive. The maximum SSID length can only contain
between 2 and 32 characters, including characters from ! (char
33) to ~ (char 126).
This button opens a page where you can configure the
Protection Mode you activated on the Configuration > Wireless
> Advanced > Wireless [#] page. If Protection Mode is not active,
ignore this option.
refer to
For more information,
page 141
.
This button opens a page where you can configure upload and
download limits per station. For more information, refer to
Limiting" on page 143
This button opens a page where you can configure access
controls for the WLAN. For more information, refer to
"Controlling Access to the Wireless Network" on page 144
Isolated : Selecting Isolated causes the traffic from this WLAN
to terminate at the AP.
Bridge to WAN : The default setting, Bridge to WAN forwards
packets arriving on this WLAN to the WAN (uplink) port and
eventually to their external destinations using Layer 2
forwarding.
Local Subnet NAT and Route to WAN : This setting allows
routing of wireless packets to their destinations using Layer 3
network address translation (NAT).
Bridge to L2TP Tunnel : Uses Layer 2 Tunneling Protocol to
deliver packets encapsulated with an L2TP header in UDP
datagrams.
Configuring Wireless Settings
"Setting Threshold Options" on
.
Configuring the AP
"Rate
.
133