Associating A Wireless Client With The Ap; Checking The Tr069 Status (Flexmaster Management Only) - Ruckus Wireless ZoneFlex 7782 Installation Manual

Preparing the 7782 Access Point at the Depot and Shipping to the Field
Verifying AP Operation
6. Connect the Ethernet cable from the Data In port on the PoE injector to your network's
router or switch.
Continue with

Associating a Wireless Client with the AP

1. In the client device's wireless interface, select the SSID configured in the
Wireless # Settings"
2. Connect the client device to the selected WLAN SSID.
After the wireless client successfully connects to the wireless LAN, continue with
the TR069 Status (FlexMaster Management Only)"
from the Power Source and the Network"
Checking the TR069 Status (FlexMaster Management
Only)
If you configured the AP to report to a FlexMaster server on the network
Setting the FlexMaster Server Address"
AP can successfully communicate with the FlexMaster server. You can do this by checking
the TR069 status on the AP's web interface.
1. In the AP's web interface, go to the Administration > Management page.
2. Scroll down to the TR069 Status section.
3. Check the value for Last successful contact. If it shows a date in green, then the AP
was able to communicate successfully with FlexMaster.
Continue with
30
Associating a Wireless Client with the
on page 26 section.
Disconnecting the AP from the Power Source and the
AP.
on page 30 or
on page 31.
on page 27), then make sure you verify that the
"Configuring
"Checking
"Disconnecting the AP
("(Optional)
Network.