Ruckus Wireless ZoneFlex 7055 User Manual page 164

Table 55. Common Wireless settings (Continued)
Channel
Channel Width
Country Code
AeroScout RFID tag
detection (some APs)
AeroScout Engine
communication daemon
(some APs)
Ekahau Engine
communication daemon
(some APs)
ERC IP (some APs)
ERC Port (some APs)
If you want to make changes to any of these settings, go to the Configuration >
Wireless page. Refer to
tion.
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A
Shows the wireless channel that the AP is currently using.
If you set the wireless channel to SmartSelect, this field
Channel # [SmartSelect] .
shows the value
11n devices only. Displays whether the channel width is
set to 20MHz or 40MHz.
Shows the country code that the AP has been set to use.
Verify that the AP is using the correct
CAUTION!
country code to make sure it uses only the allowed
radio channels in your region. Selecting the incorrect
country code may result in violation of applicable laws.
Enabled if you enabled AeroScout RFID tag
Shows
detection. The default setting is
Up if the communication agent on the AP is able
Shows
to relay location data from AeroScout Tags to the
AeroScout Engine.
If the communication agent is unable to relay data or
AeroScout tag detection is disabled, this field shows
Down .
Shows Enabled if you have enabled Ekahau RFID tag
detection. Default is disabled.
Ekahau Real Time Location System RTLS Controller IP
address.
TCP port used by the Ekahau Real Time Location
System RTLS Controller.
Configuring Common Wireless Settings
Managing the AP
Viewing Common Wireless Settings
Disabled .
for more informa-
164