Ruckus Wireless ZoneFlex 7055 User Manual page 187

• Layer 3 & Layer 4 (
well as source & destination ports. This policy uses upper layer protocol
information, when available, to generate the hash. This allows packets
destined for a particular network peer to be distributed across both physical
links, although a single connection is limited to one of the physical links.
For fragmented packets, layer 4 information is omitted.
This algorithm is not fully 802.3ad compliant.
• Layer 2 & Layer 3 (
as well as source & destination IP addresses. This algorithm places all traffic
to a particular network peer on the same physical link. For non-IP traffic, the
formula is the same as for the layer2 transmit hash policy. This policy is
intended to provide a more balanced distribution of traffic than layer2 alone,
especially in environments where a layer3 gateway device is required to reach
most destinations. This algorithm is 802.3ad compliant.
• Add or Delete (
ports (ethx) are part of the bond interface (bond0). At a bare minimum, to enable
LACP on the AP this option must be used to add both physical ports to the bond
interface.
Examples
Enable with defaults:
:set bond bond0 add eth0
:set bond bond0 add eth1
Enable and modify LACP rate & distribution algorithm:
:set bond bond0 add eth0
:set bond bond0 add eth1
:set bond bond0 xmit-hash 1
:set bond bond0 lacp-rate 1
Apply VLANs untag ID to bonded interface:
:set interface bond0 type trunk untag 777
Caveats
• As of this writing, the controller and AP Web UIs do not expose LACP settings
or configuration. If an AP is configured via AP CLI to bond its Ethernet ports,
then any per-Ethernet port setting in the Web UIs are ignored by the AP.
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A
xmit-hash 1
) uses source & destination IP addresses as
xmit-hash 2 ) uses source & destination MAC addresses
add|delete
) are used to explicitly define which physical Ethernet
187