Ruckus Wireless ZoneFlex 7055 User Manual page 169

Table 56. Management Access Options (Continued)
Option
PoE Operating
Mode (some APs)
Primary and
Controller Addr
3 If you want to use TR-069 or SNMP to manage the AP, then configure the settings
listed in
Table 57. TR-069 and SNMP Management Options
Option
Auto
SNMP only
FlexMaster only
DHCP Discovery
FlexMaster Server URL
Digest-authentication
Username/Digest-
authentication password
Periodic FlexMaster Inform
Interval
4 Click Update Settings to save your changes. A confirmation message appears
at the top of the page.
You have completed configuring the management access options.
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A
Description
AUTO = allow the AP to decide if it is to operate off of 802.3at or
802.3af power over Ethernet, or 802.3af PoE = force the AP to
operate off of 802.3af power over Ethernet. Default = AUTO.
Note: As described in
can operate off of 802.3af power, but the feature set is reduced.
Refer to Set Controller Address/Enabled above.
Table 57.
Description
Enables the Ruckus Wireless device to be managed by
either SNMP server, Ruckus Wireless ZoneDirector, or
Ruckus Wireless FlexMaster.
Only allow SNMP management.
Only allow FlexMaster management.
URL of server providing DHCP.
URL of the FlexMaster server.
This information is automatically generated by the AP and
used for authentication with FlexMaster. Change this value
only if you want the AP to connect to another access
control server (ACS).
Interval at which the device should attempt to contact
FlexMaster. Default = 15 minutes.
Enabling Other Management Access Options
ZoneFlex R710 AP section, the R710 AP
Managing the AP
169