Check The Leds; Associate A Wireless Client With The Access Point; Check The Tr069 Status (Flexmaster Management Only) - Ruckus Wireless ZoneFlex 2741 User Manual

Installing the Access Point
Step 2: Verifying Access Point Operation

Check the LEDs

Perform a spot-check using the LEDs to verify that the Access Point is operating
normally. If the Access Point is operating normally and your wireless client was able
to associate with it:
The PWR LED is green.
■
The LAN LED is green, and if traffic if passing through, it flashes green. Open a
■
Web browser window, type www.ruckuswireless.com in the address bar, and
then press <Enter>. The LAN LED should flash green as your wireless client
connects to the Ruckus Wireless Web site through the Access Point.
The WLAN LED is green. This indicates that at least one wireless client is
■
connected to the Access Point's WLAN service.
If you do not have Ruckus Wireless ZoneDirector on the network, the DIR LED is
■
off. This indicates that the Access Point is operating in standalone mode. If there
is a ZoneDirector device on the network, the DIR LED is green.

Associate a Wireless Client with the Access Point

1. On the administrative computer, verify that the wireless interface is enabled. On
Windows XP, click All Programs > Connect To > Wireless Network Connection
to enable the wireless interface.
2. In the system tray, right-click the
click View Available Wireless Networks.
3. In the list of available wireless network, click the network with the same SSID as
you configured in "Configure Wireless # Settings"
set the SSID to Ruckus Wireless AP, click the wireless network named Ruckus
Wireless AP.
4. Click Connect.
Your wireless client connects to the wireless network. After the wireless client connects
to the wireless network successfully, the wireless client icon in the system tray changes
to .
Check the TR069 Status (FlexMaster Management
Only)
If you configured the Access Point to report to a FlexMaster server on the network,
make sure you verify that it can successfully communicate with the FlexMaster server.
You can do this by checking the TR069 status on the Access Point's Web interface.
1. Log in to the Access Point's Web interface.
2. Go to the Administration > Management page.
3. Scroll down to the TR069 Status section.
(Wireless Network Connection) icon, and then
on page 26. For example, if you
30