Ruckus Wireless ZoneFlex 7055 User Manual page 168

Table 56. Management Access Options (Continued)
Option
Telnet Port
SSH Access
SSH Port
HTTP Access
HTTP Port
HTTPS Access
HTTPS Port
Certification
Verification
Controller
Discovery Agent
(LWAPP)
Cloud Discovery
Agent (FQDN)
Set Controller
Address
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A
Description
This field lists the default Telnet port of 23 — only if Telnet is active.
You can manually change this port number, if required.
By default, this option is enabled (active).
This field lists the default SSH port of 22—only if SSH is active. You
can manually change this port number if required.
This option is disabled by default.
This field lists the default HTTP port of 80, if HTTP has been
activated. You can manually change this port number if required.
By default this option is enabled. This connection mode requires a
security certificate, a copy of which has been pre-installed in the
device.
This field lists the default HTTPS port of 443—only if HTTPS has
been activated. You can manually change this port number if
required.
This notes whether the security certificate linked to the HTTPS
settings has been passed or not.
• Enabled (default) -- Lightweight Access Point Protocol controller
discovery on. (Refer to
• Disabled -- LWAPP controller discovery off.
• Enabled (default) -- Fully Qualified Domain Name cloud discovery
on; requires enabled LWAPP controller discovery Enabled. (Refer
Release Notes for details.)
to
• Disabled -- FQDN cloud discovery off.
• Enabled -- The AP uses an IP address to search for the primary
and/or secondary SCG, SZ, vSZ or ZD controller. When Set
Controller Address is Enabled, enter the required primary
controller IP address and the optional secondary controller IP
address.
• Disabled (default) -- The AP does not use IP address(es) to search
for SCG, SZ, vSZ or ZD controllers.
Enabling Other Management Access Options
Release Notes for details.)
Managing the AP
168