Troubleshooting The Installation - Ruckus Wireless ZoneFlex 7055 User Manual

Troubleshooting the Installation

If the startup sequence does not work, verify that the network name (SSID) and
security settings (if you enabled them) on the AP match the settings on your wireless
device.
• Disconnect the AP from the power source, wait 5 seconds, reconnect it, and
then wait 60 seconds before attempting a reconnection.
• Disconnect and reconnect the AP and the PC.
• Replace the Ethernet cable with a new one if the relevant LAN port LED is not
illuminated. (LEDs in each port light up during a successful connection.)
If all else fails, you can reset the AP to its factory defaults (and start over).
1 Insert a straightened-out paper clip into the reset button hole.
2 Press and hold the Reset button for at least eight (6) seconds.
You can now reconnect your computer directly to the AP (as described in
Connecting the AP to the Administrative Computer" on page
over with installation, using the default network settings.
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A
Installing the AP
Troubleshooting the Installation
"3.
84), and then start
96