Ruckus Wireless ZoneFlex 7055 User Manual page 129

Table 44. Common Wireless settings (Continued)
AeroScout RFID
Ekahau RFID
External Antenna
3 Click Update Settings to save your settings.
Band Selection on the 7321
The 7321 is a dual-band selectable (2.4 GHz or 5 GHz) single radio AP. This means
it can operate on the 2.4 GHz band or the 5 GHz band at any time, but not both at
the same time. You can select the radio band from the Configuration > Wireless
page, as shown in
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A
Enabled to support AeroScout RFID tag detection.
Select
To check the status of the AeroScout communication agent
(which relays location data from AeroScout Tags to the
AeroScout Engine), go to the Status > Wireless page. Refer
to Viewing Common Wireless Settings
NOTE: For other AeroScout-related configuration, refer to
the AeroScout documentation that was shipped with your
AeroScout Tag and AeroScout Engine.
NOTE: If ZoneDirector exists on the network, then you can
enable AeroScout RFID tag detection on all its managed APs
at once. Refer to the ZoneDirector online help for more
information.
Enabled to support Ekahau RFID tag detection, and
Select
then enter the IP address and port number of the Ekahau Real
Time Location System Controller (ERC).
NOTE: This option only appears if you are using the 7372-E
AP.
The 7372-E AP provides an external antenna port which allows
you to attach an external antenna to extend the range of your
wireless network. To enable the AP to use the external antenna,
select the Enabled option in this section. This option is disabled
by default.
Figure 60.
Configuring the AP
Configuring Wireless Settings
for more information.
129