Checking The Leds - Ruckus Wireless ZoneFlex 7055 User Manual

3 In the list of available wireless networks, click the network with the same SSID
as you configured in
87. For example, if you set the SSID to Ruckus Wireless AP, click the
page
wireless network named Ruckus Wireless AP.
4 Click Connect.
Your wireless client connects to the wireless network.

Checking the LEDs

Perform a spot-check using the LEDs to verify that the AP is operating normally.
Refer to the following sections for information on how to check the LEDs on each
Ruckus Wireless AP model.
Single-Radio APs (7321/7352)
If the single-radio AP is operating normally and your wireless client was able to
associate with it:
• The WLAN LED is green.
• When you do not have Ruckus Wireless ZoneDirector on the network, the DIR
LED is off. This indicates that the AP is operating in standalone mode. If there is
a ZoneDirector device on the network, then the DIR LED is green.
Dual-Radio APs (7055/7363/7372/7982/H500/R300/R500/
R600/R700/R710)
If the dual-radio AP is operating normally and your wireless client was able to
associate with it:
• The 2.4G or 5G LED is green.
• When you do not have Ruckus Wireless ZoneDirector on the network, the DIR
LED is off. This indicates that the AP is operating in standalone mode. If there is
a ZoneDirector device on the network, then the DIR LED is green.
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A
"Configuring Wireless # (WLAN number) Settings" on
Installing the AP
Step 2: Verifying AP Operation
92