Connect The Access Point To The Network; Check The Leds; Associate A Wireless Client With The Access Point; Check The Tr069 Status (Flexmaster Management Only) - Ruckus Wireless ZoneFlex 7762 Getting Started Manual

Verifying Access Point Operation

Connect the Access Point to the Network

Connect the Access Point to the Network
If the AP is using PoE
1. Connect the Ethernet cable from the NETWORK port on the PoE injector to your
network's router or switch.
2. Connect the PoE injector to an AC power source.
If the AP is using DC power
1. Connect the Ethernet cable from the PoE IN port on the Access Point to your network's
router or switch.
2. Connect the DC cable to a DC power source.
You have completed connecting the Access Point to your live network. Perform the tasks
described in the following sections to verify that the Access Point is operating normally.

Check the LEDs

Perform a spot-check using the LEDs to verify that the Access Point is operating normally.
If the Access Point is operating normally and no wireless clients are associated with it:
The Power LED is green.
■
The Status LED shows slow blinking amber. This indicates that there are no wireless
■
clients connected to the Access Point's WLAN service.

Associate a Wireless Client with the Access Point

1. In the system tray, right-click the
click View Available Wireless Networks.
2. In the list of available wireless network, click the network with the same SSID as you
configured in
SSID to Ruckus Wireless AP, click the wireless network named Ruckus Wireless AP.
3. Click Connect.
Your wireless client connects to the wireless network. After the wireless client connects to
the wireless network successfully, the wireless client icon in the system tray changes to
Check the TR069 Status (FlexMaster Management
Only)
If you configured the Access Point to report to a FlexMaster server on the network, make
sure you verify that it can successfully communicate with the FlexMaster server. You can
do this by checking the TR069 status on the Access Point's Web interface.
34
(Wireless Network Connection) icon, and then
"Configure Wireless # Settings" on page 29. For example, if you set the
.