Check The Tr069 Status (Flexmaster Management Only); Disconnect The Access Point From The Network - Ruckus Wireless ZoneFlex 7762-S Installation Manual

Verifying Access Point Operation

Check the TR069 Status (FlexMaster Management Only)

3. Click Connect.
Your wireless client connects to the wireless network. After the wireless client connects to
the wireless network successfully, the wireless client icon in the system tray changes to
Check the TR069 Status (FlexMaster Management
Only)
If you configured the Access Point to report to a FlexMaster server on the network, make
sure you verify that it can successfully communicate with the FlexMaster server. You can
do this by checking the TR069 status on the Access Point's Web interface.
1. Log in to the Access Point's Web interface.
2. Go to the Administration > Management page.
3. Scroll down to the TR069 Status section.
4. Check the value for Last successful contact. If it shows a date in green, this indicates
that the Access Point was able to communicate successfully with FlexMaster.

Disconnect the Access Point from the Network

1. Disconnect the Access Point from the power source.
2. Disconnect the Ethernet cable that runs to the Access Point's RJ45 port from your
network's router or switch.
You are now ready to deploy the Access Point to its permanent mounting location.
38
.