Configuring Ethernet Ports - Ruckus Wireless ZoneFlex 7055 User Manual

Configuring Ethernet Ports

The Ethernet Ports configuration page allows you to define how the AP's Ethernet
ports behave. You can disable ports entirely, define trunking and packet forwarding
behavior, configure 802.1X authentication settings, and configure VLAN settings for
each port individually from this page.
1 Go to Configuration > Ethernet Ports.
Figure 69. The Configuration > Ethernet Ports page
2 Review
Port1 through Port4 (depending on AP model), which correspond to the AP's
Ethernet ports.
Table 50. Configuring Ethernet ports
Setting
Enable
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A
Table 50 and make changes as needed for each of the ports labeled
Description
All Ethernet ports are enabled by default. Unchecking this
box next to a port disables that port entirely. If you do not
want to provide wired access through the AP, uncheck
(clear) the
Enable box next to each LAN port.
Configuring the AP
Configuring Ethernet Ports
146