Associating A Wireless Client With The Ap; Checking The Tr069 Status (Flexmaster Management Only) - Ruckus Wireless SC8800-S Installation Manual

Preparing the SC8800-S AP at the Depot and Shipping to the Field
Verifying AP Operation
5. Continue with
6. Connect the Ethernet cable from the Data In port on the PoE injector to your network's
router or switch.
7. Continue with

Associating a Wireless Client with the AP

1. In the client device's wireless interface, select the SSID configured in the
Wireless # Settings"
2. Connect the client device to the selected WLAN SSID.
3. After the wireless client successfully connects to the wireless LAN, continue with

" Checking the TR069 Status (FlexMaster Management Only)"

" Disconnecting the AP from the Power Source and the Network"
Checking the TR069 Status (FlexM aster M anagement
Only)
If you configured the AP to report to a FlexMaster server on the network (see
Setting the FlexMaster Server Address"
AP can successfully communicate with the FlexMaster server. You can do this by checking
the TR069 status on the AP's web interface.
1. In the AP's web interface, go to the Administration > M anagement page.
2. Scroll down to the TR069 Status section.
3. Check the value for Last successful contact. If it shows a date in green, then the AP was
able to communicate successfully with FlexMaster.
4. Continue with
page 27.
" Associating a Wireless Client with the AP"
" Associating a Wireless Client with the AP"
on page 22 section.
on
" Disconnecting the AP from the Power Source and the Network"
on page
on page
on
page 23), then make sure you verify that the
59.
59.
" Configuring
page 26 or
on page 27.
" (Optional)
on
26