Check The Tr069 Status (Flexmaster Management Only); Disconnect The Access Point From The Network - Ruckus Wireless ZoneFlex 7762 Installation Manual

Your wireless client connects to the wireless network. After the wireless client connects to
the wireless network successfully, the wireless client icon in the system tray changes to
Check the TR069 Status (FlexMaster Management
Only)
If you configured the AP to report to a FlexMaster server on the network, make sure you
verify that it can successfully communicate with the FlexMaster server. You can do this by
checking the TR069 status on the AP's Web interface.
1. Log in to the AP's Web interface.
2. Go to the Administration > Management page.
3. Scroll down to the TR069 Status section.
4. Check the value for Last successful contact. If it shows a date in green, this indicates
that the AP was able to communicate successfully with FlexMaster.

Disconnect the Access Point from the Network

1. Disconnect the AP from the power source.
2. Disconnect the Ethernet cable that runs to the AP's RJ45 port from your network's router
or switch.
You are now ready to deploy the AP to its permanent mounting location.
Verifying Access Point Operation

Check the TR069 Status (FlexMaster Management Only)

.
33