Configuring the Access Point
Configuring Ethernet Ports
Configuring Ethernet Ports
The Ethernet Ports configuration page allows you to define how the Access Point's
Ethernet ports behave. You can disable ports entirely, define trunking and packet
forwarding behavior, configure 802.1X authentication settings, and configure VLAN
settings for each port individually from this page.
Figure 50.
The Configuration > Ethernet Ports page
To configure LAN ports
1. Go to Configuration > Ethernet Ports.
2. Review the following table and make changes as needed for each of the ports
labeled PORT 1 through PORT 4 (depending on AP model), which correspond to
the AP's Ethernet ports.
Setting
Enable
Description
All Ethernet ports are enabled by default.
Unchecking this box next to a port disables that
port entirely. If you do not want to provide wired
access through the AP, uncheck (clear) the Enable
box next to each LAN port.
92