Configuring Ethernet Ports; Configuring Ethernet - Ruckus Wireless ZoneFlex 2741 User Manual

Configuring Ethernet Ports

The Ethernet Ports configuration page allows you to define how the Access Point's
Ethernet ports behave. You can disable ports entirely, define trunking and packet
forwarding behavior, configure 802.1X authentication settings, and configure VLAN
settings for each port individually from this page.
Figure 32. The Configuration > Ethernet Ports page
To configure LAN ports
1. Go to Configuration > Ethernet Ports.
2. Review the following table and make changes as needed for each of the ports
labeled PORT 1 through PORT 4 (depending on AP model), which correspond to
the AP's Ethernet ports.
Setting Description
Enable All Ethernet ports are enabled by default. Unchecking this box
next to a port disables that port entirely. If you do not want to
provide wired access through the AP, uncheck (clear) the Enable
box next to each LAN port.
Configuring the Access Point
Configuring Ethernet Ports
65