Configuring Ethernet Ports - Ruckus Wireless ZoneFlex series User Manual

Configuration
Configuring the AP
You have completed adding an entry to the MAC address table. If you have additional
MAC addresses you want included, click Add new entry, and then repeat these steps
until you have entered all the stations you want. There is a limit of 128 rows.
Removing a MAC Address
Remove MAC addresses from the Access Control list.
To remove a MAC address from the ACL table, click the Cancel button under the
Remove column, and then click Update. The ACL table refreshes, and the MAC address
that you deleted disappears from the table.

Configuring Ethernet Ports

The Ethernet Ports configuration page allows you to define how the AP's Ethernet ports
behave.
You can disable ports entirely, define trunking and packet forwarding behavior, configure
802.1X authentication settings, and configure VLAN settings for each port individually
from this page.
1. Go to Configuration > Ethernet Ports.
Figure 61: The Configuration > Ethernet Ports page
2. Review the following table and make changes as needed for each of the ports labeled
Port1 through Port4 (depending on AP model), which correspond to the AP's Ethernet
ports.
116 ZoneFlex Indoor Access Point Release 104.0 User Guide