Table of Contents
Advertisement
LEDs and Reset Button/Diagnostic Ethernet Port
Use the eight LEDs to check the status of the access point and cable modem.
LEDs on the T811-CM, and
port.
Figure 6. T811-CM LEDs and reset button/diagnostic Ethernet port when the dome is pointing downwards
Table 3.
LEDs and reset button/diagnostic Ethernet port
No. Label
1
POWER
2
CM DS
3
CM US
4
ONLINE
5
CTL
6
AIR
7
2.4 GHz
T811-CM AP Installation Guide, 800-71436-001 Rev A
Table 3
describes the LEDs and the reset button/diagnostic Ethernet
Description
• Off: AP off.
• Blinking red: Boot up in process.
• Solid Green: AP on.
• Blinks when searching for downstream (DS), then solid when DS is locked. Also
blinks during CM boot when power is applied.
• Off when upstream (US) is searching, and then blinks as upstream power is
increased/ranged and then solid when upstream ranging is complete. Also
blinks during CM boot when power is applied.
• Off until CM DS and CM US are solid ON, then blinks as the CM obtains an IP
address and a configuration file, and then comes online and LED is solid. Also
blinks during CM boot when power is applied.
• On when the Access Point is being managed by a Ruckus Wireless controller.
• Off: The Access Point is operating in standalone mode, or the uplink is through
its wired Ethernet interface. The wireless uplink interface is down.
• Solid green: The AP is operating as a Mesh AP (MAP), and the wireless signal to
its uplink AP is good.
• Off: The 2.4GHz WLAN service is down.
• Solid green: The 2.4GHz WLAN service is up and at least one client is associated.
• Solid amber: The 2.4GHz WLAN service is up. No clients are associated.
Installing the T811-CM
LEDs and Reset Button/Diagnostic Ethernet Port
Figure 6
shows the
20
Advertisement
Table of Contents
