Leds And Reset Button/Diagnostic Ethernet Port - Ruckus Wireless T504 Installation Manual

LEDs and Reset Button/Diagnostic Ethernet
Port
Use the eight LEDs to check the status of the access point and cable modem.
5 shows the LEDs on the T504, and
button/diagnostic Ethernet port.
Figure 5. T504 LEDs and reset button/diagnostic Ethernet port when the dome is pointing
downwards
3
2
1
Table 3.

LEDs and reset button/diagnostic Ethernet port

No. Label
1 POWER
2 CM DS
3 CM US
T504 Strand Mount Concurrent AP with Integrated CM Installation Guide, 800-70610-001 Rev A
Table 3
4
Description
• Dark: Off.
• Red: Boot up in process.
Green: On.
•
• Blinks when searching for downstream (DS), then solid when DS
is locked. Also blinks during CM boot when power is applied.
• Off when DS is searching, and then blinks as upstream power is
increased/ranged and then solid when upstream ranging is
complete. Also blinks during CM boot when power is applied.
LEDs and Reset Button/Diagnostic Ethernet Port
describes the LEDs and the reset
5
Installing the T504
Figure
6
7
8
9
19