Configuring Ethernet Ports - Ruckus Wireless SmartCell 8800-S User Manual

Configuring Ethernet Ports

The Ethernet Ports configuration page allows you to define how the AP's Ethernet
ports behave. You can disable ports entirely, define trunking and packet forwarding
behavior, configure 802.1X authentication settings, and individually configure VLAN
settings for each port from this page.
1 Go to Configuration > Ethernet Ports.
Figure 42. The Configuration > Ethernet Ports page
2 Review the following table and make changes as needed for each of the ports
labeled PORT 1 through PORT 4 (depending on AP model), which correspond
to the AP's Ethernet ports.
Table 30. Individual Ethernet port options
Setting
Enable
Port Type
ZoneFlex Outdoor Access Point 100.0.0 User Guide, 800-70725-001 Rev B
Description
All Ethernet ports are enabled by default. Unchecking this box
next to a port disables that port entirely. If you do not want to
provide wired access through the AP, uncheck (clear) the
Enable box next to each LAN port.
"Setting Ethernet Port Type" on page 109
See
detailed information.
Trunk Port : This port passes all VLAN traffic.
•
Access Port : This port provides network access.
•
• General Port : User-defined VLAN membership.
Configuring Ethernet Ports
Configuring Wireless # (WLAN Number) Settings
for more
106