Installation - NEC Express5800 120Rj-2 User Manual

User Guide

Installation

Take the following steps to install the CPU.
1. See the section
2. Pull out the server from the rack.
3. Remove the logic cover and drive cover. See
"Drive Cover" on page 141
4. Remove the PCI riser module. See
page 166
5. Remove two screws securing the support arm.
6. Remove the support arm from the chassis.
Press firmly the support arm before removing the screws.
7. Remove the processor duct from the chassis.
"Preparing Your System for Upgrade" on page 137
.
Figure 93: Removing the Support Arm
Note: Loosen the screws when the support arm comes up.
Figure 94: Removing the Processor Air Duct
"Logic Cover" on page 143
.
"Installing and Removing a PCI Board" on
146
www.nec-computers.com
to prepare.
and