Making Connections; Connecting Peripheral Devices - NEC Express5800 120Rj-2 User Manual

User Guide

Making Connections

Connecting Peripheral Devices

The server is provided with connectors for wide variety of peripheral devices on its
front and rear. The figure on the next page illustrates available peripheral devices for
the server in the standard configuration and locations of the connectors for the devices.
Observe the following instructions to use the server safely. Fail-
ure to follow these instructions may cause a fire, personal injury,
or property damage. See
page
■
Do not connect any interface cable with the power cord of
the server plugged to a power source.
■
Do not use any unauthorized interface cable.
■
Power off the server and a peripheral device before connec-
tion. Connecting a powered peripheral device to the pow-
ered server will cause malfunctions and failures.
■
To connect a third-party peripheral device or interface cable
to the server, consult with your sales agent for availability of
such a device or cable. Some third-party devices may not
be used for the server.
■
A leased line cannot be connected directly to the serial port
connectors.
■
Secure the power cord(s) and interface cables with a tie
wrap.
■
Form the cables in such a way that they will not come into
contact with the door or the guide rails on the sides of the
server.
■
Form the power cord with a slight slack at the AC inlet of the
server. This is to prevent the power cord from coming off
when the server is pulled out from the rack.
■
Do not apply any pressure to the plug of the power cord.
Caution
135.
Caution
"General Safety Information" on
47
www.nec-computers.com