NEC Express5800 120Rj-2 User Manual page 293

User Guide
RAID controller as a data disk, clear the RAID Controller's
configuration information before you perform the Express
Setup.
Re-installing to the hard disk drive which has been upgraded to Dynamic Disk
You cannot re-install Windows Server 2003 if the current partition of the hard disk
drive upgraded to Dynamic Disk remains. If you want to keep the current partition, see
"Appendix 6: Installing Microsoft Windows Server 2003 without Using Express Setup"
on page 320 or
without using the Express Setup Tool" on page 341
About the System Partition Size
The system partition size can be calculated using the following formula.
Size necessary to install the system+ Paging File Size + Dump File Size
+ Application Size
Size necessary to install the system
= 3500MB (Windows Server 2003 R2)
= 3500MB (Windows Server 2003 with Service Pack1)
= 3500MB (Windows Server 2003 R2 with Service Pack2)
= 5300MB (Windows Server 2003 R2 + ServicePack 2 CD-ROM)
Paging File Size (Recommended)= Mounted Memory Size * 1.5
Dump File Size= Mounted Memory Size + 12MB
Application Size= Required Size
■
The above-mentioned paging file size is recommended for
collecting debug information (memory dump). A paging file
with an initial size large enough to store the dump file in the
boot drive is required.
The correct debug information might not be able to be col-
lected due to a virtual memory shortage if the paging file is
insufficient, so set a size large enough for the entire system.
■
The maximum paging file size which can be set on one parti-
tion is 4095MB. If the above paging file size exceeds
4095MB, specify 4095MB for the paging file size.
■
The maximum dump file size for the system with more than
2GB memory mounted is '2048MB + 12MB'.
Notes: If you connect the LSILogic MegaRAID SAS 8480E
"Appendix 7: Installing Microsoft Windows Server 2003 x64 Editions
.
Caution
293
www.nec-computers.com