NEC Express5800 120Rj-2 User Manual page 127

User Guide
Setting a Hot Spare
The procedures below are based on the following asuumption:
Add a HDD to a RAID5 virtual disk configured with three HDDs and assign a newly
added HDD as Hot Spare.
1. Start WebBIOS.
Make sure that the status for the added HDD is indicated as "UNCONF
GOOD" in the right frame of the Top Menu.
2. Select "():1:3" (newly connected HDD) in [Physical Drives].
3. The Physical Drive properties are displayed.
4. Select [Make Global HSP] or [Make Dedicated HSP] on the lower right of the
screen, and then click [Go] on the lower center of the screen.
Global HSP:
Dedicated HSP:
Figure 79: Top Menu Screen
Indicates the Hot Spare available for all DGs.
Indicates the Hot Spare available only for the specific DG.
You need to specify the target DG.
127
www.nec-computers.com