Graphics Accelerator Driver - NEC Express5800 120Rj-2 User Manual

User Guide
If you want to use AFT/ALB feature:
1. Open the Teaming Wizard.
* The procedure in the case of the standard start menu
* The procedure in the case of the classic start menu
a. Click Start menu, point to [Settings] and click [Control Panel].
b. Click [Administrative Tools].
c. Click [Computer Management] and double click the [(Network Adapter
2. Select [Teaming] tab and then check on [Team with other adapters] and click
[New Team...].
The [New Team Wizard] dialog box appears. Click [Next]. (Specify a name for
the team if it necessary.)
3. Select the adapters to include in the team.
4. Select "Adapter Fault Tolerance" or "Adaptive Load Balancing" and click
[Next].
5. Click [Finish].
6. If it is necessary to set the adapter priority setting, follow the steps below.
Otherwise, go through to step 7.
a.
b.
c.
d.
e.
f.
7. The setup goes back to the [Intel(R) PROSet for Wired Connections] dialog
box. Click [OK].
8. Restart the system.

Graphics Accelerator Driver

The drivers for the graphics accelerator cards that are installed in the server will setup
automatically.
If you remove an additional graphics card, make sure to remove its corresponding
driver.
Should it be necessary to install manually the drivers, follow the procedure below.
1. Insert the NEC ExpressBuilder DVD into the optical disc drive.
If the autorun menu is displayed, close the menu screen.
Click Start menu, point to [Control Panel], [administrative tools], and
click [Computer Management] and then double click the [(Network
Adapter Name)] in the Network Adapter list.
Name)] in the Network Adapter list.
Click the [Settings] tab on [TEAM:xxx #yy Properties].
Click [Modify Team].
Point to the adapter [Intel(R)PRO/1000....] and click [Set Primary] or
[Set Secondary].
Click [OK].
The setup will go back to [EAM:xxx #yy Properties] and the priority
setting will display in the list ().
Click [OK]
356
www.nec-computers.com