NEC Express5800 120Rj-2 User Manual page 245

User Guide
Error Error message
code
0B80 BMC Memory Test Failed.
0B81 BMC Firmware Code Area CRC check failed.
0B82 BMC Core Hardware failure.
0B83 BMC 1BF or 0BF check failed.
0B8B BMC progress check timeout.
0B8C BMC command access failed.
0B8D Could not redirect the console - BMC Busy -
0B8E Could not redirect the console - BMC Error -
0B8F Could not redirect the console - BMC
Parameter Error -
0B90 BMC Platform Information Area corrupted.
0B91 BMC update firmware corrupted.
0B8A BMC SEL area full
0B8F Could not redirect the console BMC
Parameter Error
0B92 Internal Use Area of BMC FRU corrupted.
0B93 BMC SDR Repository empty.
0B94 IPMB signal lines do not respond.
0B95 BMC FRU device failure.
0B96 BMC SDR Repository failure.
0B97 BMC SEL device failure.
0B98 BMC RAM test error.
0B99 BMC Fatal hardware error.
0B9A BMC not responding.
0B9B Private I2C bus not responding.
0B9C BMC internal exception.
0B9D BMC A/D timeout error.
0B9E SDR repository corrupt.
0B9F SEL corrupt.
0BB0 SMBIOS – SROM data read error.
0BB1 SMBIOS – SROM data checksum bad.
8100 Memory Error detected in DIMM group #1.
8101 Memory Error detected in DIMM group #2.
8102 Memory Error detected in DIMM group #3.
8103 Memory Error detected in DIMM group #4.
8104 Memory Error detected in DIMM group #5.
8105 Memory Error detected in DIMM group #6.
8150 NVRAM cleared by jumper.
Table 31: POST Error Messages (Continued)
Recommended Action
Turn off the power once and then on again to start the
server. If the error cannot be corrected, contact your
service representative.
Start the SETUP and select [Server] - [Event Log
configuration] - [Clear All Error Logs] and press Enter
to clear event logs.
Turn off the power once and then on again to start the
server. If the error cannot be corrected, contact your
service representative.
This is not a fatal error. Turn off the power once and
then on again to restart the server. If the error cannot
be corrected, contact your service representative.
Turn off the power once and then on again to restart
the server. If the error cannot be corrected, contact
your service representative.
This is not a fatal error. Turn off the power once and
then on again to restart the server. If the error cannot
be corrected, contact your service representative.
Turn off the power once and then on again to start the
server. If the error cannot be corrected, contact your
service representative.
Update the RMC firmware. If the error cannot be
corrected, contact your service representative.
Turn off the power once and then on again to start the
server. If the error cannot be corrected, contact your
service representative.
Contact your service representative.
Contact your service representative to replace the
DIMM in the relevant group.
245
www.nec-computers.com