Cleaning The Mouse; Cleaning An Optical Drive And Optical Disc - NEC Express5800 120Rj-2 User Manual

User Guide

Cleaning the Mouse

The mouse operation depends on the degree of smoothness of the internal ball rotation.
To keep the mouse ball clean, use the mouse in a place with little dust.
To clean the mouse:
1. Prepare cold or lukewarm water, neutral detergent, alcohol, two dry soft
clothes, and cotton swabs.
2. Power off the server.
The POWER/SLEEP lamp goes off.
3. Turn the mouse upside down, and rotate the mouse ball cover counterclockwise
to remove it.
4. Take out the ball from the mouse. Cover the bottom of the mouse with your
hand, and turn your hand holding the mouse (the mouse is on your palm with
the button upward). The mouse ball is released onto your palm.
5. Soak a soft cloth in neutral detergent that is diluted with cold or lukewarm
water, and squeeze it firmly.
6. Rub off stains on the mouse ball. Softly wipe the mouse ball with the cloth
prepared in Step 5.
7. Wipe the mouse ball with a dry soft cloth.
8. Wipe three small rollers inside the mouse with a cotton swab soaked with
alcohol. Wipe stains slowly and carefully by rotating rollers with the tip of the
cotton swab.
9. Blow out any dust from the mouse. Protect your eyes from the dust.
10. Put the mouse ball back into the mouse.
11. Place the mouse ball cover, and rotate it clockwise until it is locked.

Cleaning an Optical Drive and Optical Disc

A dust-accumulated tray or a dusty optical drive may cause the device not to read data
correctly.
To Clean an Optical Drive:
1. Power the server.
The POWER/SLEEP lamp is lit.
2. Press the optical drive tray Open/Close button on the front of the optical drive.
The tray os openning.
3. Hold the disc and take it out from the tray.
fingers.
Note: Do not touch the signal side of the disc with your
262
www.nec-computers.com