Removal - NEC Express5800 120Rj-2 User Manual

User Guide
6. Change the Redundant fan jumper setting from the position 1-2 (Normal) to 2-
3 (Redundant Configuration).
To avoid system malfunction, leave other jumpers at its default
position.
7. Install the components you removed previously.

Removal

Follow these steps to remove or replace the hot-swap fan.
1. Pull out the server from the rack.
2. Remove the drive cover. See
3. Locate the failed fan.
Fault lamp on the fan turns on when a fan failure occurs. A fan failure is also
indicated by NEC ESMPRO and system event log.
Figure 184: Redundant Fan Jumper
A: Jumper position
Caution
"Drive Cover" on page 141
210
www.nec-computers.com
.