Problems At Initial System Start-Up - NEC Express5800 120Rj-2 User Manual

User Guide

Problems at initial System Start-up

Problems that occur at initial system start-up are often caused by incorrect installation
of components or incorrect configuration. Hardware failure is a less frequent cause.
■ Are all cables properly connected and secure?
■ Is AC power available at the wall outlet?
■ Are the configuration settings correct in Setup? Are all drivers properly installed?
■ Are all the expansion cards fully seated in their slots on the motherboard?
■ Are all DIMMs installed correctly?
■ Is the processor fully seated in its socket on the motherboard?
■ Are switches and jumpers on the system board correct (if they have been changed
from their original default settings)?
■ Are all jumper and switch settings on optional add-on cards and peripheral devices
set correctly? Check the documentation included with these devices for details.
Ensure that there are no system resource conflicts between hardware components.
(For example, two add-on cards could inadvertently share the same interrupt,
resulting in a conflict.)
■ Are adapter cards and disk drives correctly installed?
■ Is the keyboard properly connected to the system and is it connected in the right
PS/2 port?
■ Is a bootable diskette installed in your system's floppy drive A:?
■ Is the hard disk properly formatted or defined?
■ Is the operating system properly loaded? Check the operating system documenta-
tion.
215
www.nec-computers.com