Before Using Webbios - NEC Express5800 120Rj-2 User Manual

User Guide
■
Be sure to make a backup copy of the data and to perform a
Consistency Check before starting the Reconstruction.
■
The Reconstruction is disabled in a configuration where sev-
eral virtual disks are defined in one disk group
■
During the Reconstruction, the processing rate is decreased
due to the high load.
■
The Reconstruction can be performed for the degraded or
partially degraded virtual disk. However, we recommend you
first execute a Rebuild to recover the virtual disk, then exe-
cute Reconstruction.
■
During the Reconstruction, do not shutdown or reboot the
server. If the server is shutdown by an unforeseen accident
such as power interruption, power on again as soon as pos-
sible. The Reconstruction restarts automatically.
■
In some configurationa, the Background Initialize may start
automatically once the Reconstruction is completed.
Ex: Migration with addition for a RAID5 virtual disk
The figure below shows the addition of a single 36GB HDD to a RAID5 virtual disk
configured with three 36GB HDDs.
36GB
36GB

Before Using WebBIOS

Supported Functions
■ Indication of model name and capacity of a hard disk drive (called HDD hereafter)
■ Indication of the HDD allocation status
Note the following for the Reconstruction:
Virtual disk (RAID5)
36GB
Virtual disk (RAID5)
36GB
36GB
36GB
Execute Migration with addition
36GB
36GB
93
www.nec-computers.com
[Before execution]
Capacity = 72GB
[After execution]
Capacity = 108GB