Solving Problems; Error Messages On The Virtual Lcd - NEC Express5800 120Rj-2 User Manual

User Guide

Solving Problems

Error Messages on the Virtual LCD

The NEC EXPRESSSCOPE Engine 2 (Remote Management Controller) on your
server board allows you to monitor the server status on the WEB browser-based screen
of the client PC via network.
The virtual LCD (16 digits x 2 lines) in the "Host Information" area displays the POST
codes and status message.
When POST detects an error, the POST error code is displayed on the virtual LCD
upon completion of POST. See the table for POST error codes for details.
m BIOS
m BMC
On-screen message
XX BIOS rev YYYY
CPU Reconfigured
A
B
Figure 186: Virtual LCD Screen
A: Message sent from BIOS
B: Message sent from BMC
C: Virtual LCD
D: Status indicators
Figure 187: BIOS Messages (Upper Line)
Description
POST in progress.
XX: POST code, YYYY: BIOS
version
POST completes with processor
degraded.
C
Virtual LCD
POWER ON
ATTENTION
Action
This is not an error.
Contact your service representative.
Try the following steps to cancel the
error.
1. Start BIOS SETUP.
2. Select [Main] - Processor Settings]
- [Processor Retest] - [Yes].
3. Select [Exit] - [Exit Saving
Changes].
219
www.nec-computers.com
D
Status indicato