User Guide
1. See the section
2. Pull out the server from the rack.
3. Remove the logic cover and drive cover. See
"Logic Cover" on page 143
4. Remove the PCI riser module. See
page 166
5. Remove the two screws securing the support arm.
6. Remove the support arm from the chassis.
Press firmly on the support arm to remove the screws.
7. Remove the processor duct from the chassis.
"Preparing Your System for Upgrade" on page 137
.
Figure 107: Removing the Support Arm
Note: Loosen the screws when the support arm comes up.
Figure 108: Removing the Processor Duct
"Drive Cover" on page 141
.
"Installing and Removing a PCI Board" on
156
www.nec-computers.com
to prepare.
and