Removal - NEC Express5800 120Rj-2 User Manual

User Guide
14. Start the SETUP and select [Advanced] → [Memory Configuration] to verify
that the installed DIMM shows the status "Normal". (See
on page 64
15. Select "Yes" for [Reset Configuration Data] on the [Advanced] menu.
This setting is required to change the hardware configuration data. See
Setup Utility" on page 64
16. If the Windows operating system is in use, set the paging file size to the
recommended value (total memory size × 1.5) or a greater value.

Removal

Remove the DIMM according to the following procedure.
■
To remove the failed DIMM, check the error message
appearing in POST or NEC ESMPRO to identify the DIMM
socket (group) in which the failed DIMM is installed.
■
The server operates only when at least two DIMMs are
installed.
1. See the section
2. Pull out the server from the rack.
3. Remove the logic cover and drive cover. See
"Logic Cover" on page 143
4. Remove the PCI riser module. See
page 166
5. Remove the two screws securing the support arm.
6. Remove the support arm from the chassis.
Press firmly on the support arm to remove the screws.
or details.)
for details.
Notes:
"Preparing Your System for Upgrade" on page 137
.
Figure 112: Removing the Support Arm
Note: Loosen the screws when the support arm comes up.
"Drive Cover" on page 141
.
"Installing and Removing a PCI Board" on
159
www.nec-computers.com
"BIOS Setup Utility"
"BIOS
to prepare.
and