NEC Express5800 120Rj-2 User Manual page 160

User Guide
7. Remove the processor duct from the chassis.
8. Open the levers at both sides of the socket from which you remove the DIMM.
The DIMM is unlock and ready for removal.
Figure 114: Removing the DIMM from the Socket
9. Hold the DIMM by the edges, lift it away from the socket, and store it in a anti-
static package.
10. Install the components you removed in steps 3 to 7.
11. Power on the server and verify that POST displays no error messages.
If POST displays an error message, take a note on the message and see the
POST error messages listed in
12. Start the SETUP and select [Advanced] → [Memory Configuration] →
[Memory Retest] → [Enabled] to clear the error information of the removed
DIMM. (See
13. Select "Yes" for [Reset Configuration Data] on the Advanced menu.
This setting is required to change the hardware configuration data. See
Setup Utility" on page 64
Figure 113: Removing the Processor Duct
"BIOS Setup Utility" on page 64
for details.
"POST Error Messages" on page 200
for details.)
160
www.nec-computers.com
.
"BIOS