Removing A Hard Disk Drive - NEC Express5800 120Rj-2 User Manual

User Guide

Removing a Hard Disk Drive

which the DISK lamp of the hard disk drive is amber before
starting the removal.
1. Read section
2. Unlock the front bezel with the security key and remove the front bezel.
3. Push the lever to unlock and open the handle.
4. Firmly hold the handle and hard disk drive and pull out the hard disk drive.
5. When using the server without replacing the hard disk drive, remove the hard
disk drive from the disk tray (remove the four screws) and replace the empty
tray into the slot.
6. Power on the server, and run SETUP utility.
Select [Boot] menu to set the boot priority. When you have removed hard disk
drive, the boot priority stored in BIOS is cleared.
7. Replace the front bezel.
Note: If removing a failing hard disk drive, confirm the slot in
"Preparing Your Server for Upgrade" on page 158
Figure 132: Unlocking the Hard Disk Drive
Figure 133: Pulling out the Hard Disk Drive
179
www.nec-computers.com
.