User Guide
Note: Confirm that the handle is hooked to the frame when hav-
ing inserted the hard disk drive.
7. When the handle begins to close by itself , slowly close the handle.
The drive carrier clicks into place when it is securely locked.
■
Be careful not to get your finger caught between the handle
and tray.
■
Push the drive further to check if it is firmly secured.
8. Power on the server, and run the SETUP utility.
Select [Boot] menu to set the boot priority. When you have installed hard disk
drive additionally, the boot priority stored in BIOS is cleared.
9. Replace the front bezel you removed in step 2.
There are tabs on the left side of the front bezel. Engage the tabs with the server
frame, install the front bezel, and lock it with the security key.
Caution
Figure 131: Closing the handle
178
www.nec-computers.com