NEC Express5800 120Rj-2 User Manual page 201

User Guide
18. Insert the device carrier into the device bay until it locks.
inserting the device carrier.
19. Route the SCSI cable as shown in figure below.
with electronic components on the motherboard.
20. Install the optional SCSI controller to the PCI riser card.
21. Connect the SCSI cable to the SCSI connector on the SCSI controller.
Figure 167: Connecting the SCSI Cable to the SCSI Controller
22. Install the PCI riser card in the chassis.
23. Install the components you removed previously.
24. Install the device driver.
Refer to the manual that comes with the device.
Note: Be careful not to catch the connected power cable in
Figure 166: Routing the SCSI Cable
A: SCSI cable
Note: Make sure that the SCSI cable does not make contact
A
A: SCSI Cable
B: SCSI Controller
C: PCI Riser Card
B
201
www.nec-computers.com
A
C