Exit Menu - NEC Express5800 120Rj-2 User Manual

User Guide

Exit Menu

For the 3.5-inch disk model, record the current SATA controller
options in the Peripheral Configuration page of the Advanced
menu before reloading the Setup or custom defaults. The SATA
controller options affect the RAID System configuration.
You can make the following selections on the Exit Menu. Select an option using the up
or down arrow keys, then press <Enter> to execute the option. Pressing <Esc> does
not exit this menu. You must select one of the items from the menu or menu bar to exit.
Choices
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Load Custom Defaults
Save Custom Defaults
Discard Changes
Save Changes
Caution
Table 21: Exit Menu
Description
Exits after writing all modified Setup item values to NVRAM.
F10 key can be used for this operation.
Exits leaving NVRAM unmodified. User is prompted if any of
the setup fields were modified.
Esc key can be used for this operation.
Loads default values for all SETUP items.
F9 key can be used for this operation.
Loads the custom defaults for the BIOS Setup options.
Saves the current values as custom defaults. This menu is
only available once the Load Custom Defaults option has
been used.
Read previous values of all Setup items from NVRAM.
Save changes to NVRAM without exiting the Setup.
82
www.nec-computers.com