Available Switch Options For The Windows Server 2003 Boot.ini File - NEC Express5800 120Rj-2 User Manual

User Guide
Available switch options for the Windows
Server 2003 Boot.ini file.
Many different switches will be available if you edit the Boot.ini file.
For the available switch options, refer to the following information:
■ Microsoft Knowledge Base - Article ID: 833721
"Available switch options for the Windows XP and the Windows Server 2003
Boot.ini files"
If your system has a memory capacity in excess of 4GB in its installing, adding the /
PAE switch in the Boot.ini file will enable the system to be installed with over 4GB of
memory.
However, the Microsoft operating system products which support /PAE switch option
are limited.
Refer to the following article in Microsoft Knowledge Base to check the supported
products.
■ Microsoft Knowledge Base - Aritcle ID: 291988
"A description of the 4GB RAM tuning feature and the Physical Address
Extension switch"
Below is the example on how to add /PAE switch to Boot.ini file.
1. Click [Start], point to [Settings], and then click [Control Panel].
2. In [Control Panel], double-click [System].
3. Click the [Advanced] tab, and then click [Settings] under [Setup and
Recovery].
4. Under [System Setup], click [Edit] to open [Boot.ini].
5. Add "/PAE" to the [Operating Systems] section in the [Boot.ini] file, and then
save it.
<Example of Boot.ini file>
[boot loader]
timeout=30
default=multi(0)disk(0)rdisk(0)partition(2)\WINDOWS
[operating systems]
multi (0)disk (0)rdisk (0)partition (2)\WINDOWS="Windows Server 2003" /fastdetect
multi (0)disk (0)rdisk (0)partition (2)\WINDOWS="Windows Server 2003, PAE" /
fastdetect /PAE
C:\CMDCONS\BOOTSECT.DAT="Microsoft Windows Recovery Console" /cmdcons
operating system" drop-down list box in the [Setup and
Recovery] group box, you can make your system start
automatically from the switch you specified.
Note: If you choose one of the items in the "Default
312
www.nec-computers.com