Edge-Core ECS4210-12P Reference Manual page 367

Command Usage
◆
The ports on both ends of an LACP trunk must be configured for full duplex,
either by forced mode or auto-negotiation.
◆
A trunk formed with another switch using LACP will automatically be assigned
the next available port-channel ID.
◆
If the target switch has also enabled LACP on the connected ports, the trunk
will be activated automatically.
◆
If more than eight ports attached to the same target switch have LACP enabled,
the additional ports will be placed in standby mode, and will only be enabled if
one of the active links fails.
Example
The following shows LACP enabled on ports 10-12. Because LACP has also been
enabled on the ports at the other end of the links, the
channel 1 command shows that Trunk1 has been established.
Console(config)#interface ethernet 1/10
Console(config-if)#lacp
Console(config-if)#interface ethernet 1/11
Console(config-if)#lacp
Console(config-if)#interface ethernet 1/12
Console(config-if)#lacp
Console(config-if)#end
Console#show interfaces status port-channel 1
Information of Trunk 1
Port Type
MAC Address
Configuration:
Name
Port Admin
Speed-duplex
Capabilities
Broadcast Storm
Broadcast Storm Limit
Multicast Storm
Multicast Storm Limit
Unknown Unicast Storm
Unknown Unicast Storm Limit : 64 Kbits/second
Flow Control
VLAN Trunking
Current Status:
Created By
Link Status
Port Operation Status
Operation Speed-duplex : 1000full
Up Time
Flow Control Type
Max Frame Size
Member Ports
Console#
Chapter 11
: 1000BASE-T
: 00-00-00-00-00-03
:
: Up
: Auto
: 10half, 10full, 100half, 100full, 1000full
: Enabled
: 64 Kbits/second
: Disabled
: 64 Kbits/second
: Disabled
: Disabled
: Disabled
: LACP
: Up
: Up
: 0w 0d 0h 0m 48s (48 seconds)
: None
: 0 bytes (0 bytes for tagged frames)
: Eth1/10, Eth1/11, Eth1/12,
– 367 –
| Link Aggregation Commands
Dynamic Configuration Commands
show interfaces status port-