Edge-Core ECS4210-12P Reference Manual page 531

that incoming packets will receive, and then uses the police trtcm-color-blind
command to limit the average bandwidth to 100,000 Kbps, the committed burst
rate to 4000 bytes, the peak information rate to 1,000,000 kbps, the peak burst size
to 6000, to remark any packets exceeding the committed burst size, and to drop
any packets exceeding the peak information rate.
Console(config)#policy-map rd-policy
Console(config-pmap)#class rd-class
Console(config-pmap-c)#set phb 3
Console(config-pmap-c)#police trtcm-color-blind 100000 4000 100000 6000
conform-action transmit exceed-action 0 violate-action drop
Console(config-pmap-c)#
set cos
This command modifies the class of service (CoS) value, per-hop behavior (PHB)
value, and drop precedence value (DP) value for a matching packet (as specified by
the match command) in the packet's VLAN tag. Use the no form to remove this
setting.
Syntax
[no] set cos cos-value phb-value dp-value
cos-value - Class of Service value. (Range: 0-7)
phb-value - Per-hop behavior, or the priority used for this router hop.
(Range: 0-7)
dp-value - Drop precedence used in controlling traffic congestion.
(Range: 0 - Green, 3 - Yellow, 1 - Red)
Default Setting
None
Command Mode
Policy Map Class Configuration
Command Usage
◆
The set cos command is used to set the CoS value in the VLAN tag for matching
packets.
◆
The set cos and
Therefore setting either of these commands will overwrite any action already
configured by the other command.
Chapter 21
set phb command function at the same level of priority.
– 531 –
| Quality of Service Commands