Databits - Edge-Core ECS4210-12P Reference Manual

databits

This command sets the number of data bits per character that are interpreted and
generated by the console port. Use the no form to restore the default value.
Syntax
databits {7 | 8}
no databits
Default Setting
8 data bits per character
Command Mode
Line Configuration
Command Usage
The databits command can be used to mask the high bit on input from devices
that generate 7 data bits with parity. If parity is being generated, specify 7 data bits
per character. If no parity is required, specify 8 data bits per character.
Example
To specify 7 data bits, enter this command:
Console(config-line)#databits 7
Console(config-line)#
Related Commands
parity (117)
exec-timeout
This command sets the interval that the system waits until user input is detected.
Use the no form to restore the default.
Syntax
exec-timeout [seconds]
no exec-timeout
Default Setting
600 seconds
Command Mode
Line Configuration
7 - Seven data bits per character.
8 - Eight data bits per character.
seconds - Integer that specifies the timeout interval.
(Range: 60 - 65535 seconds; 0: no timeout)
– 115 –
Chapter 4
| System Management Commands
Line