Table 64: Mac Acl Commands; Permit, Deny (Standard Ipv6 Acl) - Edge-Core ECS4210-12P Reference Manual

Chapter 9
| Access Control Lists
MAC ACLs
MAC ACLs
access-list mac
Example
Console#show ipv6 access-list standard
IPv6 standard access-list david:
permit host 2009:DB9:2229::79
permit 2009:DB9:2229:5::/64
Console#
Related Commands

permit, deny (Standard IPv6 ACL) (329)

permit, deny (Extended IPv6 ACL) (330)
ipv6 access-group (332)
The commands in this section configure ACLs based on hardware addresses, packet
format, and Ethernet type. To configure MAC ACLs, first create an access list
containing the required permit or deny rules, and then bind the access list to one or
more ports.

Table 64: MAC ACL Commands

Command
access-list mac
mac access-group
permit, deny
mac access-group
show mac access-group
show mac access-list
This command adds a MAC access list and enters MAC ACL configuration mode. Use
the no form to remove the specified ACL.
Syntax
[no] access-list mac acl-name
acl-name – Name of the ACL. (Maximum length: 16 characters, no spaces or
other special characters)
Default Setting
None
Command Mode
Global Configuration
Function
Creates a MAC ACL and enters configuration mode
Binds a MAC ACL to all ports
Filters packets matching a specified source and destination
address, packet format, and Ethernet type
Binds a MAC ACL to a port
Shows port assignments for MAC ACLs
Displays the rules for configured MAC ACLs
– 334 –
Mode
GC
GC
MAC-ACL
IC
PE
PE