Dot1X Timeout Quiet-Period - Edge-Core ECS4210-12P Reference Manual

connected the network and the process is handled transparently by the dot1x
client software. Only if re-authentication fails is the port blocked.
◆
The connected client is re-authenticated after the interval specified by the
dot1x timeout re-authperiod
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x re-authentication
Console(config-if)#
Related Commands
dot1x timeout re-authperiod (225)
dot1x timeout
This command sets the time that a switch port waits after the maximum request
quiet-period count (see
Use the no form to reset the default.
Syntax
dot1x timeout quiet-period seconds
no dot1x timeout quiet-period
Default
60 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout quiet-period 350
Console(config-if)#
dot1x timeout
This command sets the time period after which a connected client must be re-
re-authperiod authenticated. Use the no form of this command to reset the default.
Syntax
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
page 222) has been exceeded before attempting to acquire a new client.
seconds - The number of seconds. (Range: 1-65535)
seconds - The number of seconds. (Range: 1-65535)
– 225 –
Chapter 7
command. The default is 3600 seconds.
| Authentication Commands
802.1X Port Authentication