Lldp Med-Fast-Start-Count - Edge-Core ECS4210-12P Reference Manual

Chapter 23
| LLDP Commands
lldp med-fast-start-
count
lldp
notification-interval
This command specifies the amount of MED Fast Start LLDPDUs to transmit during
the activation process of the LLDP-MED Fast Start mechanism.
Syntax
lldp med-fast-start-count packets
seconds - Amount of packets. (Range: 1-10 packets; Default: 4 packets)
Default Setting
4 packets
Command Mode
Global Configuration
Command Usage
This parameter is part of the timer which ensures that the LLDP-MED Fast Start
mechanism is active for the port. LLDP-MED Fast Start is critical to the timely
startup of LLDP, and therefore integral to the rapid availability of Emergency Call
Service.
Example
Console(config)#lldp med-fast-start-count 6
Console(config)#
This command configures the allowed interval for sending SNMP notifications
about LLDP MIB changes. Use the no form to restore the default setting.
Syntax
lldp notification-interval seconds
no lldp notification-interval
seconds - Specifies the periodic interval at which SNMP notifications are
sent. (Range: 5 - 3600 seconds)
Default Setting
5 seconds
Command Mode
Global Configuration
Command Usage
◆
This parameter only applies to SNMP applications which use data stored in the
LLDP MIB for network monitoring or management.
◆
Information about changes in LLDP neighbors that occur between SNMP
notifications is not transmitted. Only state changes that exist at the time of a
– 602 –