Interface Address Configuration And Utilities - Edge-Core ECS4210-12P Reference Manual

Chapter 26
| IP Interface Commands

Interface Address Configuration and Utilities

Interface Address Configuration and Utilities
ipv6 default-gateway
Table 140: IPv6 Configuration Commands
Command
show ipv6 nd raguard
show ipv6 neighbors
This command sets an IPv6 default gateway to use when the destination is located
in a different network segment. Use the no form to remove a previously configured
default gateway.
Syntax
ipv6 default-gateway ipv6-address
no ipv6 address
ipv6-address - The IPv6 address of the default next hop router to use when
the destination is located in a different network segment.
Default Setting
No default gateway is defined
Command Mode
Global Configuration
Command Usage
◆
All IPv6 addresses must be according to RFC 2373 "IPv6 Addressing
Architecture, " using 8 colon-separated 16-bit hexadecimal values. One double
colon may be used in the address to indicate the appropriate number of zeros
required to fill the undefined fields.
◆
The same link-local address may be used by different interfaces/nodes in
different zones (RFC 4007). Therefore, when specifying a link-local address,
include zone-id information indicating the VLAN identifier after the % delimiter.
For example, FE80::7272%1 identifies VLAN 1 as the interface from which the
ping is sent.
◆
An IPv6 default gateway must be defined if the destination has been assigned
an IPv6 address and is located in a different IP segment.
◆
An IPv6 default gateway can only be successfully set when a network interface
that directly connects to the gateway has been configured on the switch.
(Continued)
Function
Displays the configuration setting for RA Guard
Displays information in the IPv6 neighbor discovery cache PE
– 656 –
Mode
PE