Table 140: Ipv6 Configuration Commands; Ipv6 Interface - Edge-Core ECS4210-12P Reference Manual

IPv6 Interface

This switch supports the following IPv6 interface commands.

Table 140: IPv6 Configuration Commands

Command
Interface Address Configuration and Utilities
ipv6 default-gateway
ipv6 address
ipv6 address autoconfig
ipv6 address eui-64
ipv6 address link-local
ipv6 enable
ipv6 mtu
show ipv6 default-gateway
show ipv6 interface
show ipv6 mtu
show ipv6 traffic
clear ipv6 traffic
ping6
traceroute6
Neighbor Discovery
ipv6 nd dad attempts
ipv6 nd ns-interval
ipv6 nd raguard
ipv6 nd reachable-time
clear ipv6 neighbors
Chapter 26
Function
Sets an IPv6 default gateway for traffic
Configures an IPv6 global unicast address, and enables
IPv6 on an interface
Enables automatic configuration of IPv6 addresses on an
interface and enables IPv6 on the interface
Configures an IPv6 global unicast address for an interface
using an EUI-64 interface ID in the low order 64 bits, and
enables IPv6 on the interface
Configures an IPv6 link-local address for an interface and
enables IPv6 on the interface
Enables IPv6 on an interface that has not been configured
with an explicit IPv6 address
Sets the size of the maximum transmission unit (MTU) for
IPv6 packets sent on an interface
Displays the current IPv6 default gateway
Displays the usability and configured settings for IPv6
interfaces
Displays maximum transmission unit (MTU) information for
IPv6 interfaces
Displays statistics about IPv6 traffic
Resets IPv6 traffic counters
Sends IPv6 ICMP echo request packets to another node on
the network
Shows the route packets take to the specified host
Configures the number of consecutive neighbor
solicitation messages sent on an interface during duplicate
address detection
Configures the interval between IPv6 neighbor solicitation
retransmissions on an interface
Blocks incoming Router Advertisement and Router
Redirect packets
Configures the amount of time that a remote IPv6 node is
considered reachable after some reachability confirmation
event has occurred
Deletes all dynamic entries in the IPv6 neighbor discovery
cache
– 655 –
| IP Interface Commands
IPv6 Interface
Mode
GC
IC
IC
IC
IC
IC
IC
NE, PE
NE, PE
NE, PE
NE, PE
PE
PE
PE
IC
IC
IC
IC
PE