Edge-Core ECS4210-12P Reference Manual page 553

Command Usage
This command applies when the switch is serving as the querier
proxy host when IGMP snooping proxy reporting is enabled
Example
ip igmp snooping
This command adds a port to a multicast group. Use the no form to remove the
vlan static port.
Syntax
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆
◆
Example
The following shows how to statically configure a multicast group on a port.
Console(config)#ip igmp snooping vlan 1 proxy-query-resp-intvl 20
Console(config)#
[no] ip igmp snooping vlan vlan-id static ip-address interface
vlan-id - VLAN ID (Range: 1-4094)
ip-address - IP address for multicast group
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12/28)
port-channel channel-id (Range: 1-8/12)
Static multicast entries are never aged out.
When a multicast entry is assigned to an interface in a specific VLAN, the
corresponding traffic can only be forwarded to ports within that VLAN.
Console(config)#ip igmp snooping vlan 1 static 224.0.0.12 ethernet 1/5
Console(config)#
– 553 –
Chapter 22
| Multicast Filtering Commands
(page
IGMP Snooping
(page 540), or as a
540).