Mvr Source-Port-Mode Dynamic - Edge-Core ECS4210-12P Reference Manual

Chapter 22
| Multicast Filtering Commands
Multicast VLAN Registration
mvr source-port-
mode dynamic
mvr upstream-
source-ip
This command configures the switch to only forward multicast streams which the
source port has dynamically joined. Use the no form to restore the default setting.
Syntax
[no] mvr source-port-mode dynamic
Default Setting
Forwards all multicast streams which have been specified in a profile and bound to
a domain.
Command Mode
Global Configuration
Command Usage
◆
By default, the switch forwards any multicast streams within the address range
set by a profile, and bound to a domain. The multicast streams are sent to all
source ports on the switch and to all receiver ports that have elected to receive
data on that multicast address.
◆
When the mvr source-port-mode dynamic command is used, the switch only
forwards multicast streams which the source port has dynamically joined. In
other words, both the receiver port and source port must subscribe to a
multicast group before a multicast stream is forwarded to any attached client.
Note that the requested streams are still restricted to the address range which
has been specified in a profile and bound to a domain.
Example
Console(config)#mvr source-port-mode dynamic
Console(config)#
This command configures the source IP address assigned to all MVR control packets
sent upstream on all domains or on a specified domain. Use the no form to restore
the default setting.
Syntax
mvr [domain domain-id] upstream-source-ip source-ip-address
no mvr [domain domain-id] upstream-source-ip
domain-id - An independent multicast domain. (Range: 1-5)
source-ip-address – The source IPv4 address assigned to all MVR control
packets sent upstream.
Default Setting
All MVR reports sent upstream use a null source IP address
– 586 –